For detailed specifications, please refer to the COMBGEN5-70 Manual.
- Differential output - can also provide single ended outputs, one with positive going pulse, the second with negative going pulse.
- Pulse height adjustable +1 to +5V peak into 50 ohms, on positive output, with concurrent -1 to -5V peak on negative output
- Produces differential pulse on positive edge of input clock
- Input clock may be 20-100MHz sinewave or 0.5-100MHz square wave, producing comb to 4GHz. Usable energy to >10GHz.
- Differential outputs are designed to drive matched 50 ohm loads, but can drive any load, including short, without damage. Has integral fan.
- Power Requirements: -12V @ 120mA and +18V @ 90mA.
Frequency spectrum, from DC to 5GHz of the Phase Splitter Pulser, when set for its narrowest possible full-amplitude (10V peak) differential pulse. Pulse repetition frequency is 100 MPPS in this example, resulting in comb teeth spaced 100 MHz apart.
Pulse produced when set to narrow gaussian
Pulse produced when set to medium width gaussian
Pulse produced when set to ultra-wide gaussian with flat top
